Unsolved
1 Rookie
•
20 Posts
0
45
December 21st, 2024 17:19
Aurora R13, Crucial 32GB DDR5-4800 UDIMM, issues
my config says i should have 4400 but I just realized I have 4800 memory speeds is that enough to cause crash freezes on R13? i have 2 32x sticks i bought before knowing about the configs. idk when my pc started acting up before or after but my display sometimes doesnt work and pc sometimes freezes lags apphangs. if i plug the power cord in after i unplug it, it will boot then shutoff right away. but when i removed 1 of the memory sticks it didnt shutoff only when i have 1 of them or 2 of them it does that and my memory test was all good with memory86.
No Events found!
ProfessorW00d
4 Operator
•
2.3K Posts
0
December 22nd, 2024 03:16
The RAM you have is listed as "compatible with the Aurora R13" on the Crucial web site. Post a snip of the SPD and Memory tabs in CPU-Z.
Nicholas87
1 Rookie
•
20 Posts
0
December 24th, 2024 18:54
Also I just bought a new GPU. I turned my computer on. I had to turn it on twice. The monitor did not display so I press control all windows B to reset the graphics drivers and the monitor came on but the LED lights on my computer are not on and the fan GPU is not on
ProfessorW00d
4 Operator
•
2.3K Posts
0
December 25th, 2024 18:14
@Nicholas87 The CPU-Z Memory tab confirms that your RAM is running at 4400 MHz. The SPD tab will show what profiles the RAM supports.
What graphics card did you install?
I'm not familiar with a "control all windows B" short cut, but that is not the way I would update drivers for a new graphics card.
Nicholas87
1 Rookie
•
20 Posts
0
December 25th, 2024 20:07
I installed an NVIDIA 4070 Super Ventus 2x 12GB. Another issue occurred today: my PC booted with no USB power and no video until I restarted it. Additionally, if I unplugged a USB device during that state, the keyboard light would power up for a second and then power off.
This is my GPU in an idle state after boot also if that helps
and this is what i meant works sometimes only if the keyboard lights are on and the usbs work but the monitor doesnt and it made it to windows
(edited)
Nicholas87
1 Rookie
•
20 Posts
0
December 31st, 2024 05:47
I fixed the pc i reflashed the bios and it was working